Changing Bathroom Vanity Top

Start by cutting off water and disconnecting and removing old fixtures.

Changing bathroom vanity top.

Find the studs and position the vanity locate the wall studs and mark them a little higher than the top of the new vanity. Set the vanity in place. Disconnect the drain pipes from the existing sink unit using a pipe. A custom vanity top maker based in georgia will design vanity tops as long as 140 inches and as deep as 30 inches.

Measure for the new vanity top. Mark the placement of the new vanity s screw holes. Figure out the center every bathroom sink or vanity top has three holes cut at. Remove screws underneath cabinet.

Remove the doors from the vanity cabinet using a screwdriver to make it easier to work. Studfinder tape measure level pencil drill with screwdriver bits jigsaw as needed coping saw as needed small profile gauge as needed caulk gun. Measure the vanity base with a tape measure and write down the measurements. Cut caulk between backsplash and vanity with utility knife.

How to remove and replace a bathroom vanity top step 1. If the old vanity is marble or granite it will not be screwed on.